Table of Contents
Advertisement
ROP Setup Software
ROP Setup Software (HRP1005Tool.exe) is on the supplied CD-ROM.
Be sure to read "Readme.txt" on the supplied CD-ROM before installing the software.
1. Insert the CD-ROM supplied with the unit into the CD-ROM drive of the personal computer on which the
application is going to be installed.
2. Copy the entire [ROPSetup] folder on the CD-ROM to the hard disk drive of the personal computer.
3. Double-click [HRP1005Tool.exe] in the copied [ROPSetup] folder.
ROP Setup Software starts.
Use ROP Setup Software to configure various settings of the unit.
First, register this unit to ROP Setup Software from the [ROP List] tab screen.
Once the registration has been done, various settings can be configured on the [Configuration] tab, [Camera List] tab, and [UserAuth.]
tab.
When ROP Setup Software is started, the [Configuration] tab is displayed first. Click tabs to switch screens and make necessary regis-
trations and configurations.
Notice about using ROP Setup Software
When configuring settings from a personal computer using ROP Setup Software, please pay attention to the following points.
Do not start up ROP Setup Software while the unit is in the setup mode.
Do not start up ROP Setup Software on another personal computer on the same network.
After using the setup software to configure connection settings, we recommend backing up the setting data.
"ROP DATA SAVE" (see page 111)
Register the unit in ROP Setup Software [ROP List].
On the [ROP List] tab, register the IP address of the unit to be set from ROP Setup Software in [HRP1].
When connecting multiple ROPs to the network, register one of the units in [HRP1] and then register the other ROPs (AK-HRP1005) con-
nected to the network.
ROPs registered here can be selected from the list box of the [Camera List] tab. Up to 25 units can be registered.
- 124 -
Software
Advertisement
Table of Contents
