Advertisement
<CD mechanism assembly section>
Removing the CD servo board
CAUTION:
Solder the shorting round before disconnecting
the card wire extending from the pickup. If
you do not follow this instruction, the pickup
may be damaged.
1.
Remove the two screws A
loading base.
2.
Disconnect the card wire from connector CN606 on
the CD servo board. Turn over the CD servo board
as shown in Fig.2 and put aside temporarily.
3.
Solder the shorting round on the pickup board in the
CD pickup section.
4.
Disconnect the card wire from connector CN601 and
the wire from CN801 on the CD servo board.
CAUTION:
When reassembling, make sure to unsolder
the shorting round after connecting the card
wire from the pickup to the connector.
(See Fig.1, 2)
on the bottom of the
CD servo board
CN801
A
Fig.1
CD servo board
CN801
CD pickup
CD pickup
Fig.2
UX-L40R/UX-L30R
CN601
CN606
CN601
Shorting round
Pickup board
Shorting round
(Soldering)
1-15
Advertisement
