Advertisement
Removing the C.D. gear (1), (2) and (3)
Prior to performing the following procedure, remove
the CD servo board.
1.
Remove the two screws F attaching the CD base on
the bottom of the loading base.
2.
Remove the rear part of the CD base upward and
pull out the shaft e of the CD base from the camplate
on the front side of the loading base.
REFERENCE:
The CD mechanism assemly comes off
with the CD base.
3.
Remove the leaf spring on the upside of the loading
base.
4.
Remove the screw G attaching the cam plate fitting.
5.
Remove the screw H and the cam plate upward.
6.
Remove the belt from the C.D. gear (1).
7.
Pull out the C.D. gear (1), (2) and (3) respectively.
Cam plate fitting
G
Cam plate
Spring
Fig.12
(See Fig.10 ~ 13)
Loading base
H
F
CD base
(Bottom)
Fig.10
CD mechanism assembly
e
F
Fig.11
C.D. gear (3)
Belt
C.D. gear (2) C.D. gear (1)
Fig.13
UX-L40R/UX-L30R
F
Loading base
F
CD base
1-19
Advertisement
