Charging - Sharp SH-06F Instruction Manual

A docomo mini UIM card has a security code called PIN code
(nP. 70 "PIN code").
The tablet supports only docomo mini UIM card. Change the UIM
at a docomo Shop.
Before inserting or removing the docomo mini UIM card, turn off
the power. Hold the tablet securely with your hand.
Inserting docomo mini UIM card
■
1
Open the docomo mini UIM card/microSD Card
slot cover
: Hook the tip of a finger into the slot to open.
2
Hold the docomo mini UIM card with the IC
(gold) side turned down and insert it slowly into
the docomo mini UIM card slot
: Push it slowly towards inside until a click is heard.
Notch
IC (gold)
Notch
: Do not insert the docomo mini UIM card at an angle or with
the wrong side down. The docomo mini UIM card slot may be
damaged.
3
Close the docomo mini UIM card/microSD Card
slot cover
: To prevent gaps from being left between the tablet and the
docomo mini UIM card/microSD Card slot cover, close it in
the direction of the arrow (1) and push the A areas
securely (2).
Slot
docomo mini UIM
card slot (right side)
Removing docomo mini UIM card
■
1
Open the docomo mini UIM card/microSD Card
slot cover
2
Gently push the docomo mini UIM card towards
inside (1)
: Push it towards inside until a click is heard. It will come out
towards you.
3
Remove the docomo mini UIM card (2)
: Remove the docomo mini UIM card by slowly pulling it
straight out. Do not let it fall.
4
Close the docomo mini UIM card/microSD Card
slot cover
Make sure not to touch or damage the IC (gold) of the docomo
mini UIM card when handling it. Also, note that inserting or
removing the docomo mini UIM card forcibly may damage it.
Refer to the docomo mini UIM card user's guide for more
information on the docomo mini UIM card.
Do not misplace the docomo mini UIM card once it is removed.
IMEI plate
A plate on which the IMEI number (International Mobile
Equipment Identifier) is printed is stowed near the docomo mini
UIM card slot. The IMEI number is required when you contact a
repair counter that DOCOMO specifies, so do not pull it out.
Note that pulling the IMEI plate forcibly or adding forces on it
may damage the plate.
If you accidentally pull out the IMEI plate, push it back slowly
towards inside.

Charging

The internal battery is not fully charged at the time of
purchase. Be sure to charge the battery before use.
■ Cautions while charging
For details on the estimated charge time nP. 91 "Main
specifications"
The battery can also be charged with the tablet turned on (While
charging, the battery icon appears with [w] superimposed).
Do not charge for a long time with the power left turned on. If the
tablet is left turned on after charging is complete, the internal
battery charge level decreases.
In this case, an AC or DC adapter (sold separately) charges the
battery again. However, depending on the time when the tablet is
disconnected from the AC or DC adapter, the battery charge
level may be low or the battery may only be usable for a short
time.
If the tablet is left for a long time even after the charging is
completed, the battery level may decrease.
When the battery is empty and the tablet is being charged, the
charging lamp may not illuminate immediately. However,
charging is in progress.
14
Before Using the Tablet