Panasonic KX-NCP0158 Quick Installation Manual page 3

•
When driving the screws into the wall, be careful to avoid touching any metal laths, wire laths or metal
plates in the wall.
•
To prevent malfunction, deformity, overheating, rust, and discoloration, do not install or place
equipment in the following types of locations:
–
Locations where air ventilation is poor.
–
Locations that may be exposed to sulphurous gas, such as near hot springs.
–
Near devices that emit heat, such as heaters.
–
Near devices that emit electromagnetic noise, such as radios or televisions.
–
Near devices that emit high-frequency noise, such as sewing machines or welders.
•
Do not stretch or bend the cables. Also, do not allow anything to rest on the cables.
•
Use cables that are fire-resistant or fireproof.
•
The CS and the cables should never be placed near or over a radiator or other heat source.
•
Do not bundle cables that are connected to the CS with the AC power cords of machines located
nearby.
•
Make sure the cables are securely fastened to the wall.
•
The AC adaptor is used as the main disconnect device. Ensure that the AC adaptor is located near the
unit and is easily accessible.
•
Disconnect the AC adaptor cord and all cables from the unit before cleaning. Clean the unit with a soft,
dry cloth. Do not use liquid, aerosol cleaners, abrasive powders, or chemical agents to clean the unit.
•
When left unused for a long period of time, disconnect the unit from the AC outlet. When the unit
receives power from a PoE power supply, disconnect the LAN cable.
•
Medical—consult the manufacturer of any personal medical devices, such as pacemakers, to
determine if they are adequately shielded from external RF (radio frequency) energy. (The unit operates
in the frequency range of 1920 MHz to 1930 MHz, and the output peak power level is less than
0.125 W.) Do not use the unit in health care facilities if any regulations posted in the area instruct you
not to do so. Hospitals or health care facilities may be using equipment that could be sensitive to
external RF (radio frequency) energy.
Notice
SAFETY REQUIREMENTS
•
Before connecting the unit, confirm that the unit supports the intended operating environment.
•
If the unit does not operate properly, disconnect the AC adaptor cord and LAN cable, then connect
again.
•
The unit may not operate in the event of a power failure.
•
Do not move the unit while it is in use.
•
Satisfactory operation, interoperability, and compatibility cannot be guaranteed with all equipment
connected to the unit, nor with all services provided by telecommunications providers over networks
connected to the unit.
SECURITY REQUIREMENTS
•
Privacy of communications may not be ensured when using the wireless systems.
Document Version 2009-06
Important Information
Quick Installation Guide 3