Advertisement
CLEANING AND MAINTENANCE
To keep the surface of the hob and the various
components in pristine condition (grill, enamelled
covers, burner heads and flame diffusers, it is very
important to wash them in warm soapy water, rinse and
dry them well after each use.
Do not leave vinegar, coffee, milk, salty water or the
juice of lemon or tomato on enamelled surfaces for
any length of time.
WARNINGS
• Check that the heads burners and the relative burner
caps, are correctly positioned in their housings (fig. 8).
• Take care not to disturb the ignition spark plugs or
flame failure devices.
• If you find a tap is difficult to open or close do not force
it but call for technical assistance urgently.
STRUCTURE
All the cooker parts (in enamelled or painted metal, steel, or
glass) should be cleaned frequently with warm soapy water
and then rinsed and dried with a soft cloth.
OvEN CAvITY
Do not spray or wash the thermostat bulb with acid
based products (check the product label before use).
The manufacturer cannot be held liable for any
damage caused by incorrect cleaning.
The oven cavity should be cleaned after each use
to remove cooking residuals and or grease or sugar
which, if burnt on when the oven is used again, will
form deposits or unremovable stains as well as
unpleasant smells.
To maintain the shine of the enamelled parts, clean
them with warm soapy water, rinse and dry them
thoroughly. ALWAYS wash the accessories
��
��
INSTRUCTIONS FOR THE USER
used.
8
9
HOW TO CLEAN THE INNER OVEN DOOR GLASS
One of the features of our cookers is that the inner oven
door glass can be easily removed for cleaning without the
aid of specialized personnel. Just open the oven door and
remove the support securing the glass (fig.9).
AT LEAST ONE HINGE
This operation can be done also with the door
fitted on appliance, but in this way, pay attention
that when the glass is pull upwards, the force of
the hinges can close the door roughly.
OVEN DOOR REMOVAL (for certain models)
The oven door can be removed to give easier access
to the oven when cleaning.
To remove, proceed as follows:
• Open the oven door and insert rivet or nail (R) in the
hole (F) of the hinge (fig. 10).
• Partially close the door, forcing it upwards at the
same time to free stop tooth and hinge sector.
• Once the hinge is free, pull the door forwards tilting
it slightly upwards to free sector.
• To reassemble proceed in the reverse order, paying
attention to the correct position of sectors.
rEPLACING THE OvEN LAMP (fig.11)
Ensure the appliance is switched off before
replacing the lamp to avoid the possibility of
electric shock..
In the event one or both oven lamps need replacing, the
new lamps must comply with the following requisites:
15 W - 230 V~ - 50 Hz - E 14 - and must be resistant to
high temperature (300°C).
Turn glass protection cap (C) counterclockwise and
change the lamp. Re-fit the cap, screwing it back in a
clockwise direction.
14
ATTENTION!!
�
10
LOCK
�
Advertisement
