Advertisement
OVEN SEAL
The oven seal guarantees the correct functioning of
the oven. We recommend you:
• clean it, avoiding abrasive tools or products.
• check its state now and then.
If the oven door seal has become hard or is
damaged, contact our Service Centre and avoid
using the oven until it has been repaired.
SELF-CLEANING PANELS
Oven walls are protected by panels coated with a
grease-proof, microporous enamel that absorbs and
eliminates splattering during baking.
If there is a lot of liquid or grease, dry immediately
with a damp sponge and heat the oven for 2 hours
on the maximum thermostat position. Wait for the
oven to cool down and then go over it again with a
damp sponge. If you are unable to remove all the
substances, repeat the above procedure.
It is, however, advisable to periodically remove the
panels and wash them with warm soapy water and
dry them with a soft cloth.
To remove them follow these instructions:
• Extract the side grids as indicated in the previous
paragraph.
• Remove both side panels (PL) (fig.12).
• Remove back panel by unscrewing respective
locking screws (V) (fig. 13).
• Repeat previous operations in reverse order to
replace all elements.
IMPORTANT!! Position both side panels (PL) by
taking the locking pin (L) out of the hole (S) (fig. 12).
INSTRUCTIONS FOR THE USER
11
�
�
�
�
�
�
�
�
OVEN SIDE-GUIDE RAILS
For an effective cleaning of the oven side-guide rails,
these can be extracted unscrewing knurled nuts (G).
To fit the rails back in their place, first insert rear pins
in holes and then secure them with the knurled nuts
(G).
�
15
��
�
�
�
�
�
��
�
12
13
Advertisement
