Table of Contents
Advertisement
You have forgotten your ratings password.
You want to cancel the ratings level.
The ratings level returns to the factory
defaults.
1 While the unit is on
Press and hold [OK], the yellow button and
the blue button on the remote control at the
same time for more than 5 seconds.
– POWER LED starts to flash, and "00 RET"
is displayed on the screen.
2 Press [1] (right) repeatedly on the remote
control until "03 VL" is displayed on the
screen.
3 Press [OK].
The TV screen turns black.
In the following cases, HDMI authentication
takes place and a black screen is displayed:
– When "24p Output" is set to "Automatic".
– When the display is switched between 2D
and 3D images.
– When you quit the 4K playback by
displaying another screen, including the
HOME menu.
This unit does not recognize the USB
connection correctly.
Disconnect and re-connect the USB cable. If
it still does not recognize the connection, turn
this unit off and on again.
USB devices may not be recognized by this
unit when connected using the following :
– a USB hub
– a USB extension cable
If you connect USB HDD to this unit, use the
USB cable that is supplied with the HDD.
If the USB HDD is not recognized, the power
to the USB HDD may not be supplied. Supply
power from an external source.
Reference
Picture
Images from this unit do not appear on the TV
screen, or they are distorted.
An incorrect resolution is selected in "Video
Format". Reset the setting as follows:
The connected devices are changed. Reset
the setting as follows:
1 While the unit is on
Press and hold [OK], the yellow button and
the blue button on the remote control at the
same time for more than 5 seconds.
– POWER LED starts to flash.
2 Press [8] and the blue button on the remote
control at the same time for more than
5 seconds.
Set the item again. (
– When Dolby Digital Plus, Dolby TrueHD,
and DTS-HD
select "Yes" in "Default Settings" (
make proper settings.
– "4K(50p/60p) Output" will be set to "Off".
Make the correct setting again. (
PAL discs cannot be correctly viewed on an
NTSC TV.
When "3D BD-Video Playback" in the Setup
menu is set to "Automatic", images may not
be output depending on the connection
method. After removing the disc from this unit,
select "Set before play" in the Setup menu,
and select "2D Playback" in the setup screen
displayed when playing 3D discs. (
When outputting in 4K, images may be
distorted depending on the HDMI cable. Use
an HDMI cable that supports 18 Gbps.
(The supplied HDMI cable supports 18 Gbps.)
- 30 -
24)
audio are not output properly,
®
28) and
24)
26)
Advertisement
Table of Contents
