Electrolux AEG PWE3810-M User Manual page 22

22 Maintenance and cleaning
Water may come out from the filter cartridge, therefore place a cloth on the filter head and
cartridge to prevent the cabinet from getting wet.
If there is water on the base, dry it carefully.
4. Rotate the filter cartridge clockwise and pull it down to extract it
5. Open the cleaning cartridge and fill it with "Neutral Detergent"
6. Hold the cleaning cartridge from the upper larger side and insert it in the filter head by pushing it up
and rotating it counter-clockwise
7. Connect the plastic hose to the discharge water nozzle
8. Place a big container underneath the plastic hose or put the hose in a sink
9. Place a cup under the water dispense nozzle
10. Remove the safety screw and open the water discharge tap
11. Turn on the power switch
12. Immediately press the light icon and keep it pressed until LEDs start scanning
If the power LED became steady, please repeat the two last steps until LEDs start scanning
13. Wait for the power LED to flash, then press the power icon until the LEDs start scanning again
Some water will be dispensed from the water dispenser automatically
14. Wait for the power LED to flash, then remove the cleaning cartridge
Water may come out from the cleaning cartridge.
If there is water on the base, dry it carefully.
15. Insert the filter cartridge in the filter head by pushing it up and rotating it counter-clockwise
16. Press the power icon until LEDs start scanning again
17. Wait for the power LED to flash, then press the power icon until all LEDs start scanning.
Wait for all LEDs to turn off before proceeding with the next step
Some water will be dispensed from the water dispenser automatically
18. Close the water discharge tap and reinsert the safety screw
19. Restart the appliance using the power switch