Flexi Pad Control Block - Sony XKS-C9111 User Manual

a Independent key transition display section
b KEY ON buttons
a Independent key transition display section
The following information is displayed for the assigned
key on the [KEY ON] buttons.

Flexi Pad Control Block

You use the Flexi Pad control block for recalling and
saving snapshots, wipe snapshots, DME wipe snapshots,
and key snapshots, for recalling and creating macros, for
recalling and executing shotboxes and master timelines,
for entering the transition rate, and for other tasks.
• Key material name (key source name when a key source
is selected on the key bus of the cross-point control
block)
b KEY ON
buttons • DME channel or resizer being used
• Transition rate
• Transition type
b KEY ON buttons
Inserts or removes the key assigned to the button
instantaneously.
If a key is currently inserted, the corresponding key button
is lit.
You can assign a key (KEY1 to KEY8) of any switcher
bank (M/E-1 to M/E-5, PGM/PST) to the [KEY ON]
buttons in the Setup menu.
For details, see "Setting Independent Key Transition
Control Block Button Assignments" (page 411).
c AUTO TRANS (auto transition) buttons
c AUTO
Inserts or removes the key assigned to the [KEY ON]
TRANS
button with the set transition rate and transition type
buttons
automatically.
During the execution of the transition, the button is lit.
a Mode selection buttons
34
c UNDO button/
DEL button
d Bank selection
buttons
b Memory recall section