Usb/Audio Board - HP Mini 110-1020 Maintenance And Service Manual

USB/audio board

Description
USB/audio board (includes cable)
Before removing the USB/audio board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC Adapter from the computer.
4. Remove the battery (see
5. If your device has WWAN capability, remove the SIM (see
6. Remove the following components:
a. Keyboard (see
b. Hard drive or solid-state drive (see
c. Top cover (see
Remove the USB board:
1. Release the ZIF connector (1) to which the USB/audio board cable is connected, and disconnect
the cable (2).
2. Release the USB/audio board from the clip attached to the base enclosure (3), and remove the
USB/audio board (4).
Reverse this procedure to install the USB/audio board.
Battery on page 36).
Keyboard on page 40).
Mass storage devices on page
Top cover on page 48).
SIM on page 37.
45).
Component replacement procedures
Spare part number
537614-001
55