HP Mini 110-1020 Maintenance And Service Manual page 73

Before removing the display assembly, follow these steps:
1. Shut down the device. If you are unsure whether the device is off or in Hibernation, turn the device
on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the device.
3. Disconnect the power from the device by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the device.
4. Remove the battery (see
5. If your device has WWAN capability, remove the SIM (see
6. Remove the following components:
a. Keyboard (see
b. Hard drive or solid-state drive (see
c. Top cover (see
Remove the display assembly:
1. Release the tape securing the WWAN antennas(1).
2. Disconnect the following cables from the system board:
(2) Display panel cable
(3) Microphone cable
(4) Speaker cable
(5) WLAN cables
(6) WWAN cables (select models only)
CAUTION: Support the display assembly when removing the following screws. Failure to support
the display assembly can result in damage to the display assembly and other device components.
Battery on page 36).
Keyboard on page 40)
Mass storage devices on page
Top cover on page 48)
SIM on page 37.
45)
Component replacement procedures 65