System Board - HP Mini 110-1020 Maintenance And Service Manual

System board

Description
System board (includes processor and replacement thermal material)
Includes Intel Atom N280 1.66-GHz processor, 512-KB Level 2 cache, 533-MHz front-side bus (FSB) 571370-001
Includes Intel Atom N270 1.6-GHz processor, 512-KB Level 2 cache, 533-MHz front-side bus (FSB) 537662-001
Before removing the system board, follow these steps:
1. Shut down the device. If you are unsure whether the device is off or in Hibernation, turn the device
on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the device.
3. Disconnect the power from the device by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the device.
4. Remove the battery (see
5. If your device has WWAN capability, remove the SIM (see
6. Remove the following components:
a. Keyboard (see
b. Hard drive or solid-state drive (see
c. Top cover (see
When replacing the system board, be sure that the following components are removed from the defective
system board and installed on the replacement system board:
● WLAN module (see
● WWAN module, if included (see
●
RTC battery (see
●
Heat sink assembly (see
Remove the system board:
1. Release the tape securing the WWAN antennas(1).
Battery on page
Keyboard on page 40)
Mass storage devices on page
Top cover on page 48)
WLAN module on page
WWAN module on page
RTC battery on page 44)
Heat sink assembly on page
36).
SIM on page
51)
53)
59)
Component replacement procedures
Spare part number
37.
45)
61