Power Cord Set Requirements; 3-Conductor Power Cord Set; General Requirements - HP ProSignia 120 Maintenance And Service Manual

B
appendix
P C
OWER ORD
B.1 3-Conductor Power Cord Set
The wide range input feature of your computer permits it to operate from any line
voltage from 100 to 240 volts AC.
The power cord set received with the computer meets the requirements for use in the
country where you purchased the equipment.
Power cord sets for use in other countries must meet the requirements of the country
where you use the computer.
B.1.1 General Requirements
The requirements listed below are applicable to all countries:
1. The length of the power cord set must be at least 5.00 feet (1.5 m) and a maximum
of 6.56 feet (2.0 m).
2. All power cord sets must be approved by an acceptable accredited agency
responsible for evaluation in the country where the power cord set will be used.
3. The power cord set must have a minimum current capacity of 10A and a nominal
voltage rating of 125 or 250 volts AC, as required by each country's power system.
4. The appliance coupler must meet the mechanical configuration of an EN 60 320/IEC
320 Standard Sheet C5 connector, for mating with appliance inlet on the product.
S R
ET EQUIREMENTS
Power Cord Set Requirements B-1