Setup - NEC N8103-104A User Manual

4.Setup

Please follow the steps described below to set up this product.
Do not handle this product during an electrical storm.
When installing this product in the computer, please read the user's manual of the computer and
unplug the power plug from the electrical outlet. Do not insert or remove the power plug with wet
hands. Doing so can lead to faults or electric shock.
Do not pull on the lead when unplugging the power plug from the electrical outlet. Doing so can
damage the power cord and lead to shorting or electric shock.
Avoid installation in extreme temperature conditions.
Immediately after the server is powered off, its internal components such as hard disks are very
hot. Leave the server until its internal components fully cool down before installing/removing any
component.
Connect firmly.
Please connect the product to the computer firmly. A loose connection can cause a contact
failure and can lead to smoke or fire.
Explained in
Installation of a bracket
Selection of a bracket to use for this product.
Installation to the computer
Install this product to the computer.
Connecting a SAS Cable
Connect a SAS cable to this product.
SAS Controller Configurations
Change SAS controller settings as necessary.
Explained in
Software User's Guide
Installation of a SAS driver
Install an appropriate SAS driver for your operating system.
User's Guide
- 28 -
WARNING
CAUTION
->
See Software User's Guide
-> Page 29
-> Page 30
-> Page 32
-> Page 33