Table of Contents
Advertisement
4-3.Connecting a SAS Cable
To connect a SAS Cable:
Notice
1.
Confirm the power to the computer is off (power lamp off), then unplug the power cord from the
electrical outlet.
Notice
2.
Insert a SAS cable connector in this product's connector fully for firm connection. Secure the
connector on both sides with screws.
3.
Insert a cable connector (the other side) in SAS device's connector fully for firm connection.
Secure the connector on both sides with screws.
4.
Plug the power cord of the computer into the electrical outlet.
Do not connect this product to a computer or SAS device that is not recommended
by NEC Corporation. If the product is connected to a computer or SAS device that
is not recommended by NEC Corporation, the product may malfunction or fail.
Please contact the retailer or service center for the information on recommended
computers, SAS devices, or SAS cables.
If the power to the computer is on (power lamp on), shut down the operating
system and then turn off the computer.
- 32 -
Advertisement
Table of Contents
