Using The Remote Control; Installing The Battery In The Remote; Operating Range Of The Remote - Sharp DV-L88 Operation Manual

Using the Remote Control

Installing the battery in the Remote

1
Holding the release tab to the
left, slide the battery holder from
the Remote with your fingernail
catching the slit.
slit

Operating range of the Remote

Important!
• Do not subject the Remote to
strong impact.
• Do not allow the Remote to become
wet and keep it out of areas subject
to high humidity.
• The Remote may fail to work properly after
you replace its battery. When this happens,
remove the battery and leave it out for at
least five minutes. Next, reload the battery
and try again.
• The Remote may not work properly if the
remote sensor of the Player is in direct
sunlight or other strong light. Change the
orientation of the light or the Player and try
again.
• If you do not plan to use the Remote for a long time, remove its battery.
2
Place a lithium battery into the
battery holder and slide the
battery holder back into place.
• Make sure the
Release tab
Remote sensor
Signal emitter
side of the
battery is facing in the same
direction as the mark on
the battery holder. The
remote control will not
operate correctly if you insert
the battery upside-down.
15° 15°
5m
INPUT
+
– VOLUME
OPERATE /DVD
TITLE FUNCTION SHIFT