Table of Contents
Advertisement
Installation (continued)
Attaching the projector drop-prevention kit
Secure the wire rope to the projector (sold separately).
Attention
z For the combination of the projector with the ceiling mount bracket (for low ceilings) ET-PKD120S (sold
separately) and the ceiling mount bracket (for high ceilings) ET-PKD120H (sold separately), and the mounting
of the wire rope to the ceiling, please refer to the installation instructions of the ceiling mount bracket ET-
PKD120S (for low ceilings) and ET-PKD120H (for high ceilings).
(when using the ceiling mount bracket ET-PKD120S (for low ceilings))
8 - ENGLISH
A
A
1 Secure one end of the wire rope with a
captive washer screw (M6×20) to "A" on the
projector as shown on the left.
Attention
z Be sure to use the supplied flat washers and
wire rope.
z At this step, please keep the wire rope
through the opening of the mounting bracket
base.
Note
z One of the two supplied washers with this
product is for the fixing of the wire rope to the
projector and the other is for the fixing of the
wire rope to the ceiling.
2 Mount the projector with the ceiling mount
bracket ET-PKD120S (for low ceilings) to
the angle adjusting bracket.
Attention
z Pass the wire rope through to the other side
of the angle adjusting bracket during this
step.
3 Mount the projector to the ceiling.
Attention
z For the combinatioin of this projector and
the ceiling mount bracket (sold separately),
please refer to the installation instructions of
the ceiling mount bracket ET-PKD120S (for
low ceilings).
4 Pass the wire rope through to the other
side of the angle adjusting bracket and at-
tachment plate as shown on the left.
Advertisement
Table of Contents
