Philips 4010W Series Service Manual page 19

4.2 Service Positions
For easy servicing of a TV set, the set should be put face down
on a soft flat surface, foam buffers or other specific workshop
tools. Ensure that a stable situation is created to perform
measurements and alignments. When using foam bars take
care that these always support the cabinet and never only the
display. Caution: Failure to follow these guidelines can
seriously damage the display!
Ensure that ESD safe measures are taken.
4.3 Assembly/Panel Removal (for 19" 4010W )
Instructions below apply to the 19HFL4010W/12.
2
4.3.2 Small Signal Board (SSB)
Refer to Figure 4-13 for details.
Caution: it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the SSB.
1. Remove the fixation screw [1] that secure the wall mount
bracket and take out the bracket.
2. Release the clips from the LVDS connector [2] that connect
with the SSB.
Caution: be careful, as these are very fragile connectors!
3. Unplug all other connectors [3] and FFC connector [4].
4. Remove all the fixation screws [5] from the SSB.
5. The SSB can now be shifted from side connector cover,
then lifted and taken out of the I/O bracket. Refer to
Figure 4-13 for details.
Mechanical Instructions
4.3.1 Rear cover
Refer to
Warning: Disconnect the power adapter before removing the
rear cover.
1. Remove fixation screws [1] that secure the Stand assy, pull
2. At the indicated areas [3] of rear cover is secured by clips.
3. Gently lift the rear cover from the TV. Make sure that wires
1
1
3
1
1
Figure 4-12 Rear cover removal
back to
div.table
TPM15.3HE LA
Figure 4-12 for details.
out the Stand assy from the set. Then remove the fixation
screws [2] that secure the rear cover. Refer to
for details.
Be very careful with releasing those.
and cables are not damaged while lifting the rear cover
from the set.
3
4. EN 19
Figure 4-12
M4 × 16
1
Q3 × 6
2
2
19823_101.eps
2015-Otc-09