Philips 4010W Series Service Manual page 20

EN 20 4. TPM15.3HE LA
5
3
4
1
5
Figure 4-13 SSB removal
4.3.3 LED Driver Board
Caution: it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the LED Driver board.
1. Gently unplug all connectors from the board.
2. Remove all fixation screws from the board.
3. The LED Driver board can be taken out of the set now.
4.3.4 Speakers
1. Gently release the tapes that secures the speaker cables.
2. Unplug the speaker connectors from the SSB.
3. Take the speakers out.
When defective, replace the both units.
4.3.5 Option Board
1. Unplug the connector from the SSB.
2. Remove fixation screws that secure the Option board,
gently remove the board from the set.
When defective, replace the whole unit.
4.3.6 IR/LED Board
Refer to Figure 4-14 for details.
1. Unplug the connectors [1] from the IR/LED board.
2. Gently release the clips that holds the board and incline the
bottom side of the board, then take it out from the bezel.
When defective, replace the whole unit.
Figure 4-14 IR/LED Board removal
2015-Otc-09
Mechanical Instructions
4.3.7
5
4.4
5
4.4.1
19823_102.eps
19823_103.eps
back to
div.table
LCD Panel
1. Remove the stand as described earlier
2. Remove the SSB as described earlier.
3. Remove the LED Driver board as described earlier.
4. Remove the speakers as described earlier.
5. Remove the IR/LED board as described earlier.
6. Remove the Option board as described earlier.
7. Remove all other metal parts that do not belong to the LCD
panel.
8. Release all fixing clips that secure the front bezel to the
LCD panel.
9. Lift the LCD Panel from the front bezel.
When defective, replace the whole unit.
Assembly/Panel Removal (for 24"/28"
3010/5010 series)
Instructions below apply to the 24HFL3010T/12, but will be
similar for other 24"/28" models.
Rear Cover
Refer to Figure 4-15 for details.
Warning: Disconnect the mains power cord before removing
the rear cover.
1. Remove fixation screws [1] that secure the base assy, pull
out the base assy from the set. Then remove the fixation
screws [2] that secure the rear cover. Refer to
for details.
2. At the indicated areas [3] of rear cover is secured by clips.
Be very careful with releasing those.
3. Gently lift the rear cover from the TV. Make sure that wires
and cables are not damaged while lifting the rear cover
from the set.
Figure 4-15