Philips 4010W Series Service Manual page 23

1. Release the clips from the LVDS connector that connect
with the SSB [1].
Caution: be careful, as these are very fragile connectors!
2. Unplug all other connectors [2] and FFC connector [3].
3. Remove all the fixation screws from the SSB [4].
4. The SSB can now be shifted from side connector cover,
then lifted and taken out of the I/O bracket. Refer to
Figure 4-18 for details.
4
2
3
4
Figure 4-18 SSB removal
4.5.4 Power Supply Unit (PSU)
Caution: it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the PSU.
1. Gently unplug all connectors from the PSU.
2. Remove all fixation screws from the PSU.
3. The PSU can be taken out of the set now.
4.5.5 Speakers
1. Gently release the tapes that secures the speaker cables.
2. Unplug the speaker connectors from the SSB.
3. Take the speakers out.
When defective, replace the both units.
4.5.6 Stand bracket
1. Remove all fixation screws of the bracket.
2. Lift the bracket from the set.
4.5.7 IR board Control Unit
Refer to Figure 4-19, Figure 4-20
1. Unplug the connector from the SSB.
Caution: be careful, as these are very fragile connectors!
2. Remove all the fixation screws from the IR board control
unit [1].Refer to Figure 4-19
3. Remove the IR lens [2], IR board [3] from the
DECO_REAR_COVER. Refer to
When defective, replace the whole unit.
Mechanical Instructions
4
4
19820_111.eps
for details.
for details.
Figure 4-20 for details.
TPM15.3HE LA
Figure 4-19 IR board Control Unit removal 1
Figure 4-20 IR board Control Unit removal 2
4.5.8 Option Board
1. Unplug the connector from the SSB.
2. Remove fixation screw that secure the Option board, gently
remove the board from the set.
When defective, replace the whole unit.
4.5.9 WIFI module
1. Unplug the connector from the SSB.
2. Remove fixation screw that secure the WIFI module,
getntly remove the module from the set.
When defective, replace the whole unit.
back to
div.table
4.
1
1
19820_112.eps
3
2
19820_113.eps
EN 23
2015-Otc-09