Toshiba G3+ PACK Operation Manual Addendum page 23

The following specifications apply to the CC and CC1 models (NEMA 3R and NEMA 1).
Installation should conform to the 2005 National Electrical Code Article 110 (NEC) (Requirements for
Electrical Installations), all regulations of the Occupational Safety and Health Administration, and any
other applicable national, regional, or industry codes and standards.
Note: The following ratings are guidelines and shall not be the sole determining factor of the lug or
wire size used with the ASD. Application-specific applicables, wire insulation type, conductor
material, and local and regional regulations are but a few of the considerations when
selecting the actual lug and wire type to be used with the ASD.
Note: Cables and Terminals specifications are based on the rated current of the ASD — They Do
Not include a 10% Service Factor.
Table 3. Specifications for Cables and Terminals for the 12-Pulse G3+ Pack.
Model
Number
Frequency
G3+B
Command,
4660
4830
411K
416K
420K
426K
439K
445K
(RR, AM, FM)
451K40
460K
470K
481K
493K
410L
412L
414L40
415L40
G3+ Pack Addendum
Wire Size AWG
Other Signal
Ckts.
AM, FM
#20
3-Core
Shielded
#18
#20
2-Core
Shielded
(IV, RX)
Lug Size
AWG or KCmil
Input Power Lug Output Power Lug
Cable Size Cable Size
1 - (14 – 1/0)
1 - (4 – 500)
1 - (4 – 350)
2 - (6 – 350)
2 - (4 – 500)
2 - (3/0 – 250)
4 - (3/0 – 500)
4 - (1/0 – 750)
2 - (2/0 – 350)
3 - (3/0 – 500)
4 - (3/0 – 500) 6 - (1/0 – 750)
DBR Lug Cable Size
1 - (6 – 250)
1 - (1/0 – 500)
2 - (4 – 350)
17