Table of Contents
Advertisement
1. Slope-sensor decal
Installing the Kit
CT2240, LT3340, and LTF Machines
1.
Remove the 6 screws securing the control panel
to the control pod
1. Screw
2. Control panel
2.
Carefully lift off the panel, ensuring that the
connectors to the existing switches are not
disturbed.
3.
Remove the plug
4.
Insert the LED light into the console.
5.
Install the wire harness as shown in
Figure 6
(Figure
7).
Figure 7
3. Plug
4. Control pod
(Figure
7) from the console.
Figure
6.
Connect the LED light to the wire-harness
connector labeled P08
g308240
1. Wire harness
2. Connector—P08
3. LED light
4. Alarm
7.
Connect the alarm to the wire-harness connector
labeled P09
8.
Route the remaining end of the wire harness
down the control arm
9.
Use the previously-removed screws to secure
the control panel to the control pod.
10.
Raise the hood.
11.
Route the wire harness along the machine
chassis and up to the electrical panel.
12.
Use 2 bolts (M6 x 35 mm) and 2 flange nuts (M6)
to secure the slope sensor to the slope-sensor
mount
(Figure
g304897
8.
4
(Figure
8).
Figure 8
5. Connector—P09
6. Control pod
7. Control arm
8. Route the wire harness
toward the roll bar.
(Figure
8).
(Figure
8).
9).
g304404
Advertisement
Table of Contents
