Table of Contents
Advertisement
Figure 16
1. Alarm
Figure 17
1. 30 mm
6.
Connect the wire harness as follows:
•
Wire harness connector labeled P01:
Connect to one of the 6-pin sealed
connectors located on the main harness next
to the grass chute on the right side of the
machine.
•
Wire harness connector labeled P02:
Connect to the slope sensor.
7.
Route the wire harness under the platform with
the machine wire harness and into the steering
column
(Figure
18).
g307375
g308238
2. 210 mm
1. Wire-harness-routing direction
8.
Connect the remaining wire-harness connectors
as follows:
•
Wire harness connector labeled P08:
Connect to the LED light.
•
Wire harness connector labeled P09:
Connect to the alarm.
9.
Use a cable tie to coil together any additional
amount of wire harness in front of the battery
(Figure
19).
1. Coil the wire harness here.
10.
Use cable ties to secure the wire harness away
from moving parts and pinch points.
11.
Install the battery cover and the dashboard,
steering wheel, and front cover.
7
Figure 18
Figure 19
g307376
g307373
Advertisement
Table of Contents
