Table of Contents
Advertisement
UNIT CONTROLLER
7.13.4.9 Optional functions configuration
This menu allows to configure the optional functions for system, space heating or space cooling, DHW and Emergency operation.
Hydraulic separator:
Enable or disable a Hydraulic separator
or a buffer tank. See detailed information
below.
Smart function:
To block or limit the heat pump or
increase demand due to electricity
availability. See detailed information on
Smart function chapter.
Hydraulic separator
DWH Tank position:
This selection option is not available for
YUTAKI S COMBI since DHW tank is located
before buffer tank in any case.
Pre: DHW tank and the 3 way valve are
located between Heater Plate exchanger and
buffer tank.
Post: DHW tank and the 3 way valve are
located after buffer tank.
97
PMML0575 rev.1 - 09/2021
1 / 2
2 / 2
Energy configuration:
Setup of power consumption readings. See
detailed information below.
Heating Auto On/Off:
To stop automatically stop heating operation when
the daily average outdoor temperature of the
previous day is higher than the defined Switch-
OFF temperature. See detailed information below.
Auto Heat/Cool:
Allows to set automatic switch over to heating and
cooling operation using the same daily average
outdoor temperature of the previous day as in
Heating auto ON/OFF.
Hot water tank:
Configure the optional functions for the DHW. See
detailed information below.
Emergency operation:
Enable or disable emergency operation for space
heating or DHW. See detailed information below.
Hydraulic separator status:
Enable if there is a Hydraulic separator or a
buffer tank installed. Check that WP3 is set
in output 2 (see section
"7.13.4.10 Inputs,
Outputs and Sensors
configuration").
Advertisement
Table of Contents
