Table of Contents
Advertisement
Figure 33
1. Upper notch
5.
Remove the breather cap
6.
Wipe the dipstick off and thread the breather
cap into the reservoir.
7.
Remove the dipstick and verify that the fluid is at
the upper notch
(Figure
cap.
8.
If the fluid level is low, remove the filler plug and
slowly add hydraulic fluid into the reservoir to
raise the level to the upper notch on the dipstick
(Figure
34).
Figure 34
1. Filler plug
9.
Install the filler plug.
g206553
2. Breather cap
(Figure
33).
33). Install the breather
g207827
Replacing the Hydraulic
Filter
Service Interval: Every 100 hours
1.
Park the machine on level ground, adjust the
jack stand to ensure that the machine is level,
fully retract the splitting wedge, and shut off the
engine.
2.
Place a drain pan under the filter and replace
the filter
(Figure
3.
Clean up any spilled fluid.
27
35).
Figure 35
g206495
Advertisement
Table of Contents
