Cisco AS5400XM Quick Start Manual page 36

Step 13 Enter yes to configure the Gigabit Ethernet 0/0 interface to connect the gateway to a LAN, and then respond to the
remaining questions to configure the Fast Ethernet port:
Do you want to configure GigabitEthernet0/0
Configure IP on this interface? [no]: yes
IP address for this interface: 172.22.50.10
Subnet mask for this interface [255.255.0.0] : 255.255.255.128
Class B network is 172.22.0.0, 25 subnet bits; mask is /25
Do you want to configure GigabitEthernet0/1
Note The Gigabit Ethernet interfaces in the Cisco AS5350XM universal gateway can be configured as Fast Ethernet
interfaces in ROM monitor mode. For information on the ROM monitor, see the universal gateway ROM monitor
information in the Cisco IOS Configuration Fundamentals Configuration Guide for your Cisco IOS software
release.
Step 14 Configure your serial interfaces by responding to the following prompts:
Do you want to configure Serial0/0
Configure IP on this interface? [no]: yes
Configure IP unnumbered on this interface? [no]:
IP address for this interface interface: 172.22.50.11
Subnet mask for this interface: 255.255.0.0
Do you want to configure Serial0/1 interface? [yes]: no
Configuring interface Group-Async1:
Step 15 After you complete the configuration script, the setup script displays the configuration command script. Review your
new configuration and then make the appropriate selection below:
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
Enter your selection [2]:
Initial Configuration Using the CLI (Manual Configuration)
This section shows how to perform basic configuration using the command-line interface (CLI).
Step 1 To proceed with manual configuration using the CLI, enter no.
Would you like to enter the initial configuration dialog? [yes/no]: no
Step 2 To terminate autoinstall and continue with manual configuration, press Return:
Would you like to terminate autoinstall? [yes] Return
Step 3 To bring up the
Router>
...
Router>
Enter privileged EXEC mode.
Step 4
Router> enable
Router#
Step 5 Enter global configuration mode. You are in global configuration mode when the prompt changes to
Router# configure terminal
36
interface? [no]: yes
interface? [no]:
interface? [no]: yes
prompt, press Return:
Router(config)#.