Cisco AS5400XM Quick Start Manual page 42

.
Rcvd: 25762 packets, 1052214 bytes
0 format errors, 891 checksum errors, 0 overrun
Sent: 8891 packets, 222264 bytes, 0 dropped
Configuring a T1 or E1 Feature Card
This section shows how to configure a T1 or E1 feature card. On a Cisco AS5350XM or Cisco AS5400XM universal gateway,
you can allocate the available channels for channelized T1 and E1 in the following ways:
• You can configure all channels to support ISDN PRI.
• If you are not running ISDN PRI, you can configure all channels to support robbed-bit signaling (also known as
channel-associated signaling).
• You can configure all channels in a single channel group.
• You can configure mix and match channels supporting ISDN PRI, channel grouping, and channel-associated signaling
(CAS).
• You can configure mix and match channels supporting ISDN PRI, channel grouping, and robbed-bit signaling across the
same T1 line. For example, on the same channelized T1 you can use the pri-group timeslots 1-10,24 command,
channel-group 11 timeslots 11-16 command, and ds0-group 17 timeslots 17-23 type e&m-fgb command. This is an unusual
configuration because it requires you to align the correct range of time slots on both ends of the connection.
For configuration information about leased-line or nondial use, see the Cisco IOS Dial Technologies Configuration
Note
Guide, available online. You can access this document at Technical Support & Documentation > Product Support >
Cisco IOS Software > Cisco IOS Software Release you are using > Configuration Guides.
The T1 and E1 controller numbering convention is slot/port in CLI commands. Feature card slot numbering starts from
Note
the motherboard and works up from left to right. Slot 0 is reserved for the motherboard. The CT1/E1 feature card slots
are numbered sequentially from 1 to 7. Port numbering is from 0 to 7.
Use the enable command and password to enter privileged EXEC mode. You are in privileged EXEC mode when the
Step 1
prompt changes to
Gateway> enable
Password: password
Gateway#
Step 2 Enter global configuration mode. You are in global configuration mode when the prompt changes to
Gateway# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Gateway(config)#
Step 3 Enter controller configuration mode to configure your controller slot and port. Slot values range from 1 to 7. Port
values range from 0 to 7 for T1 and E1.
Gateway(config)# controller [t1 | e1] slot/port
Gateway(config-controller)#
Enter the telco framing type.
Step 4
• For the CT1 controller, enter either esf or sf:
Gateway(config-controller)# framing esf
• For the CE1 controller, enter crc4:
Gateway(config-controller)# framing crc4
42
.
Gateway#
.
Gateway(config)#