Cisco AS5400XM Quick Start Manual page 39

After you have configured AAA security, all access will require a username and password. Make sure that your
Caution
login name and password are working before you exit or reboot. If you are unable to get back into your universal
gateway, see the password recovery instructions at the following URL:
http://www.cisco.com/warp/public/474/pswdrec_as5300.shtml
Gateway# login
User Access Verification
Username: admin
Password:
Gateway#
Tip To save the gateway configuration, save it to NVRAM. See the "Saving Configuration Changes" section on page 60.
Note For comprehensive information about how to implement a Cisco AAA-based security environment, see the relevant
documents at Technical Support & Documentation > Product Support > Cisco IOS Software > Cisco IOS Software
Release you are using > Configuration Guides.
Configuring Basic Dial Access
To commission a basic dial access service, use the procedure below to perform the following tasks:
• Create two loopback interfaces.
• Bring up the Gigabit Ethernet interface.
• Add an IP route to the default gateway.
Enter global configuration mode. You are in global configuration mode when your prompt changes to
Step 1
Gateway(config)#
Gateway# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Gateway(config)#
Assign the IP addresses as in the following example, and create an IP route to the default gateway:
Step 2
Gateway(config)# interface loopback 0
Gateway(config-if)# ip address 172.22.99.1 255.255.255.255
Gateway(config-if)# exit
Gateway(config)# interface loopback 1
Gateway(config-if)# ip address 172.22.90.1 255.255.255.0
Gateway(config-if)# exit
Gateway(config)# interface GigabitEthernet 0/0
Gateway(config-if)# ip address 172.28.186.55 255.255.255.240
Gateway(config-if)# no shutdown
Gateway(config-if)# exit
Gateway(config)# ip route 0.0.0.0 0.0.0.0 172.28.186.49
.
39