Toro 007 Maintenance Manual page 14

TKU--- C 01140--- 1 EN 0404
If welding must be done close to any of the control modules, disconnect the module
D
wiring before beginning welding.
The ground cable of the welding machine must be connected as close as possible
D
to the welding location. The ground cable may not be connected so that the current
can flow through a bearing, joint coupling, sealing surface, lever, or control cable.
Use a protective mask when welding.
D
Arrange adequate ventilation.
D
Arrange protection against fire.
D
MAINTENANCE AND LUBRICATION
13 (64)