Toro 007 Maintenance Manual page 30

TKU--- C 01140--- 1 EN 0404
3.4. Every 250 hours
D D D D Change engine oil and filters
Run engine until operating temperature is
reached; then shut down.
Drain oil pan and reinstall drain plug, using
a new gasket if required.
Change oil filters.
Clean the filter adapter.
Fill the new filters with clean lubricating oil,
and lightly coat the filter seals with the
same oil.
Add oil as required to bring the oil level to
the FULL mark on the dipstick.
Start engine and run at low idle. Check lube oil pressure gauge reading.
Shut engine down. Wait 20 min.
Recheck oil level and add oil if needed, bringing oil level to FULL mark on the dipstick.
D D D D Change transfer gearbox oil
Drain oil from the bottom of the gearbox
and reinstall drain plug, using a new gas--
ket if required. Be careful when draining
hot oil.
Fill gearbox through filler opening until fluid
comes up to LOW mark on transmission
dipstick.
Run engine for two minutes at idle.
Recheck level of fluid in gearbox with
engine running at idle.
Add quantity necessary to bring fluid level to LOW mark on dipstick. Recheck with hot oil.
Bring oil level to FULL mark on dipstick.
MAINTENANCE OPERATIONS
29 (64)