Advertisement
Fresh-water connection
- If the appiance is not kept upright dur-
Connect the hose to a water tap using the
ing transport, any water left inside may
enclose parts and in accordance with the in-
seep into the control module and cause
stallation instruction
subsequcent error with programme
Water pressure:
function.
Minimum 3x10
4
-maximum 10
6
Pa.
The appliance must be drained in the fol-
If the water pressure is higher,install a
lowing sequence:
pressure reducing valve.
Water temperature
We recommend that you use cold water.
If you do use hot water,the temperature
should not exceed 60
Electrical connection
This appliance should only be connectedto a
220V AC source via a properly installed erath
socket.See nameplate for size of required
fuse.
Disconnecting the dishwasher
Protection from freezing
Here too,it is important that tasks are carried
temperature
out in the correct sequence:
If the appliance is installed in a location
always unplug the appliance from the mains
where there is a risk of freezing
electricity first of all.
temperature (e.g. in a holiday home),all
Pull plug out of wall socket.
water must be completely drained out pf
Turn off water suplly.
the interior (see "Transporting the
Disconnect drain and water input hoses .Re-
dishwasher").
move screws in underside of wrok surface.
Turn OFF the tap,disconnect the supply
Detach base board, if fitted.
hose and allow to drain
Pull out appliance and carefully withdraw
hoses at same time.
Transporting the dishwasher
Drain water from the dishwadher.Secure all
loose parts.The appliance should only be
transported in an upright position.
- Set main switch to ON
- Select the NORMAl programme.
The programme duration in minutes
is shown in the numerical display.
- Wait for approximately 4 minutes.
- Terminate the programme by
pressing Intensive and
Rinse simultaneously.
- Wait a further minute and then
switch the appliance off.
Installation instructions
Individual installation
Advertisement
