Advertisement
Interruping the programme
Drying
- Set Start/Pause 9 to PAUSE.
When a programme without drying
- Indicator lights extinguish. The
process is selected,the dinner service
programme is retained in the
is dried solely by afterheat
dishwasher memory.
- If or the appliance has already heated up
- Press the 6 or 7 or 8 button,and set
and then the appliance door ajar for
several minutes and then close.
- Press the 6 or 7 or 8 button again,
Otherwise, the appliance door may fly
open due to expansion.
- In oder to continue with thestored
programme, set the button 9 to START.
Programme the delay timer
You can delay the start of a programme in
increments of ONE hour for up to NINE
hours.
- Switch dishwasher ON.
Changing the programme
- Immediately press the Preset button 2 .
Once selected,the programme can not be
The numercial display 3 changes to .
changed during operation.To be change the
- Press the Preset button as many times
programme, switch off the main switch and
as necessary unit the numercial
repeat the programme.
display shows the required delay.
- To erase the time delay setting, keep
pressing the Preset button until
disappears in the numerical display.
The timer function is cancelled if the
dishwasher is switched off.
You can change your programme selection
as often as you like during the intervening
period before the dishwasher starts up.
washing programme
and set the programme to Drying.
Care and maintenance
Care and maintenance
Regular inspection and maintenance of your
appliance helps to prevent problems from
occurring. This saves time and aggravation.
You should therefore carefully inspect the in-
side of your dishwasher from time to time.
Overall condition of appliance
- Check that no grease or scale has
Spray arms
accumulated on the inside of the
Lime and remants of food in the washing
dishwasher.
water can block the nozzles in the spray arms
If you discover any deposits:
12 and 13 and the arm mountings.
- Clean the interior of the dishwasher
thorough with a detergent solution.
- Inspect the nozzles in the spray arms
for blocked holes due to remnants of food.
Filters
- If necessary, pull the lower spray arm 13
upwards and lift it off.
The filters 14 prevent larger remnants of
- Unscew the upper spray arm 12 .
food or other objects from getting inside
- Clean both spray arms under runing water.
the pump.This residue can occasionally
- Refit the spray arms. Ensure that the
clog up the filters.
lower arm has locked into place and the
The filter system consists of a coarse/
upper one is screwed tight.
microfilter and a flat fine filter.
- Inspect the filters for obstructions every
time the dishwasher has been used.
- Remove the filters if necessary. After you
have unscrewed the coarse/microfilter,
you can lift out the fine filter. Remove
any obstructions and clean the filters
under runing water.
-Re-insert the fine filter and secure it in
place by screwing the coarse/microfilter tight.
Advertisement
