Connections - NEC M Series User Manual

Connections

NOTE: Do not connect or disconnect cables when turning on the monitor's main power or other
external equipment's power as this may result in a loss of image.
NOTE: Do not use an attenuating (built-in resistor) audio cable. Use an audio cable without a built-in
resistor. Using an audio cable with a built-in resistor will lower the sound level.
Before making connections:
▪ Turn off the device's power before connecting it to the monitor.
▪ Refer to the device's user manual for available connection types and instructions for the device.
For further instructions on connections, please refer to standard user's manual of the base
model monitors M551, M651.
For using Touch Panel
1. Turn off the monitor.
2. Install the equipment.*1
▪ Using slot -in PC (SDM): Connect the B type connector to the USB upstream port on the left back
side of the monitor marked with "TOUCH" and the A type connector to the downstream port on the
SDM slot -in PC.
NOTE: Please refer to the SDM slot PC's manual for connection.
NOTE: When you set option board accessory other than SDM slot-in PC, touch function may not work.
▪ Using external computer: Connect the B type connector to the USB upstream port on the left
back side of the monitor marked with "TOUCH" and the A type connector to the downstream port on
the external computer.
3. Turn on the monitor.
*1: Please contact your Sharp NEC customer support for more detailed information. Please contact your Sharp NEC
customer support for the setting of the touch panel function in multiple screens.