Table of Contents
Advertisement
2. Removal of Color Picture Tube Unit
Place the Unit face down on a soft cloth before removing the
Color Picture Tube Unit.
3. Installation of Mechanism Chassis Ass'y and TV/VCR Main C.B.A.
When installing 2 Screws (449), slide the Holder Unit of the
Cassette Up Ass'y (Refer to
CASSETTE" in SERVICE NOTES) to tighten screws. Then, slide it
back to the EJECT Position.
4. Removal of TV/VCR Main C.B.A.
When disconnecting the P4002 Flat Cable from the Connector
P4092 on the AC Head, care must be taken to hold the Connector
P4092 stable to avoid damaging it.
Otherwise, a satisfactory picture and secure precise tracking will
not be achieved. (Refer to
ADJUSTMENT" in MECHANICAL ADJUSTMENT.)
Installation of TV/VCR Main C.B.A.
A. Make sure the Mode Select SW. on the TV/VCR Main C.B.A. is in
EJECT position. If not, rotate the Mode Select SW. until the
alignment projection is in the EJECT Position.
"WHEN LOADING WITHOUT A
"TAPE INTERCHANGEABILITY
Fig. D7
28
Advertisement
Table of Contents
