Table of Contents
Advertisement
COMPLX CMP:
Complex Component
W FLMPRF:
Wirewound Flameproof
C.B.A.:
Circuit Board Assembly
P.C.B.:
Printed Circuit Board
E.S.D.:
Electrostatically Sensitive Devices
3. When replacing 0
4. Since the UHF/VHF TUNER/TV DEMODULATOR UNIT (Ref. No.
743) has already been pre-adjusted at the factory, do not try to
adjust the UHF/VHF TUNER/TV DEMODULATOR UNIT. The UHF/
VHF TUNER/TV DEMODULATOR UNIT replacement part is
available as a complete assembly unit only.
5. EEPROM IC (IC6004), TV/VCR Main C.B.A. replacement note:
When replacing EEPROM IC (IC6004) or TV/VCR Main C.B.A., be
sure to write the initial data with remote control.
6. EEP ROM IC (IC6004) replacement note:
There are 2 types of EEPROM IC (IC6004) used on the Main C.B.A.
(DIP TYPE and SOP TYPE). However, these are same reliability,
please refer to "TV/VCR MAIN C.B.A." in CIRCUIT BOARD
LAYOUT.
7. TV/VCR MAIN C.B.A. replacement note:
When the TV/VCR MAIN C.B.A.s shown below are replaced, the
Jumper wire(J801 or J810) of the new TV/VCR MAIN C.B.A. must
be cut before use. If the Jumper wire isn't cut, the power does not
turned on to the TV circuit. / As for the location of the Jumper
wire, please refer to "TV/VCR MAIN C.B.A." in CIRCUIT BOARD
LAYOUT.
resistor, a wire can be substituted for it.
81
Advertisement
Table of Contents
