Installation And Removal Of The Shield Cover - Mitsubishi Electric A1S66ADA User Manual

4 PROCEDURES AND SETTINGS BEFORE OPERATION

4.3 Installation and Removal of the Shield Cover

Hole for removal
Shield fixing screw
4 - 3
It is necessary to install the shield cover when using.
Procedures for installing and removing the shield cover are described below.
(1) Installation
Module
Shield cover
To install the shield cover to the module, install the cover to the terminal side first
as shown in the figure, then it will be completed by pushing the cover to the
module and tightening the shield fixing screw.
(2) Removal
Shield cover
To remove the shield cover from the module, remove the shield fixing screw first
and install the tip of a flat-tip screwdriver into the removal hole as shown in the
figure, then move the screwdriver towards the rear of the module to separate the
clip from the removal hole and remove the cover.
Shield fixing
screw
Module
MELSEC-A
4 - 3