Siemens Gigaset USB Stick 108 Manual page 47

Appendix
Problem
You cannot
establish a
connection to the
Access Point
Installation
cancelled under
Windows 2000
46
Causes and remedies
If you cannot establish a connection between your Gigaset USB
Stick 108 and an Access Point, try one or more of the following:
ì
Make sure that the physical connection of the Access Point
operates reliably.
ì
Make sure that the same SSID is used for the Gigaset USB
Stick 108 and the Access Point.
ì
Check whether the security settings configured for the
Gigaset USB Stick 108 match those for the Access Point, e.g.
the same key for WEP encryption.
ì
Check whether your access to the Access Point is blocked by
other security measures, e.g. by a MAC filter or filter for IP
addresses.
ì
Make sure that the IP address and the subnet mask are
correctly configured in the IP Settings tab.
As a rule, it is necessary to assign dynamic IP addresses
when operating a network in infrastructure mode.
If the following error message appears when installing the
Gigaset USB Stick 108 under Windows 2000: "1608: Unable to
create InstallDriver instance" and the installation is cancelled,
the cause is that the Microsoft Network Client component is
missing.
To install the Microsoft Network Client:
ì
Select Start – Settings – Control Panel –
Network and Dial-up Connections.
ì
Right-click on LAN Connection, and select Properties.
ì
Then click on the following Install – Client – Add –
Client for Microsoft Networks – OK.
The Microsoft Network Client component is now installed.
ì
Restart your PC to apply the change.
ì
Install the software, see the chapter "Installing the Gigaset
USB Stick 108" on page 7.