Installation of the wall bracket
DANGER! ELECTRIC SHOCK!
►
Ensure that there are no power cables or water pipes in the wall at the
location where you intend to drill the holes for the wall bracket 7 .
Drilling into a current-carrying electric cable can be potentially fatal!
1) Select a suitable installation location for the wall bracket 7:
It must be possible to remove the handheld vacuum cleaner easily and there
must be a mains power socket nearby . In addition, there should be no power
or water lines in the wall .
2) Drill two holes below each other at a distance of approx . 110 mm from each
other . The drill holes must be suitable for 5 mm wall plugs .
3) Push in the wall plugs and screw in the screws so that the heads protrude a
few millimetres .
4) Hang the wall bracket 7 with the drill holes over the two screws and ensure
that the screws slide into the slots . The wall bracket 7 should lie flush
against the wall . You can adjust the distance to the wall and compensate for
any unevenness in the wall by screwing in or unscrewing the screws .
5) Ensure that the power cable is not trapped and that it lies properly in the
cut-out .
6) Push the two accessories holders 8 into the respective catches on the left
and right of the wall bracket 7 . You can place the nozzles in the
accessories holders 8 .
7) Place the barrel plug 9 of the power adapter 0 into the wall bracket 7
from below . Secure the barrel plug 9 by turning it .
8) Plug the mains adapter 0 into a power socket .
SAST 18 A1
GB │ MT
│
49
■