Troubleshooting; Fault Causes And Rectifi Cation - Silvercrest SAB 160 B2 Operating Instructions Manual

Troubleshooting

GB
Fault causes and rectifi cation
Fault
The device will
not switch on
No sound
The CD will not
load or eject
The function
buttons are not
working
146
This section contains important information on fault identifi cation and rectifi ca-
tion. Follow the instructions to avoid hazards and damage.
WARNING
Observe the following safety instructions to avoid hazards and material
damage:
► Repairs to electrical devices should only be carried out by specialists
trained by the manufacturer. Improper repairs can cause considerable risks
to users and damage to the device.
The following table will help to identify and rectify minor faults:
Possible cause
The ignition is not switched
on.
The fuse is defective.
The volume is set to minimum. Increase the volume.
The cables are not connected
correctly.
The sound is turned off .
There is already a CD in the
device.
The CD has been inserted
the wrong way up.
The CD is dirty or defective.
The temperature in the
vehicle is too high.
Condensation on the laser
lens
There is a fault with the
device.
The control panel is not
installed correctly.
Remedy
Switch the ignition on by turning
the key.
Replace the fuse .
27
Check the cable connections.
Press the / button to turn
19
the sound back on.
Remove the CD.
Insert the CD with the label side up.
Clean the CD or insert a diff erent CD.
Allow the vehicle to air out until the
temperature has dropped back down
to the operational temperature.
Switch the device off for a few
hours and then try it again.
Press the RESET button
Check that the control panel is
installed correctly.
.
23
SAB 160 B2