Hitachi GR4000 Series Quick Start Manual page 27

Setup of GR4000-160E1
●Setup procedures
6.
Procedure
Check LED.
4.
Procedure
Attach an
interface cable.
2.
Procedure
Install a memory
card.
Procedure
Attach a powre cable.
Figure 2-5 Procedures for GR4000-160E1 setup
1.
Procedure
Attach a power cable.
Attach power cables to all the power supply units in GR4000-160E1.
When connecting the device to a power supply unit, use only grounded
Warning
power outlets. Failing to use grounded outlets creates a shock hazard.
Use the power cable provided with a chassis. If you use a power cable other
Warning
than this, it could cause a fire or an electric shock.
Before attaching a power cable, make sure that all the switches of GR4000 are
NOTE
turned OFF.
2.
Procedure
Install a memory card.
Insert a memory card into both the memory card slot 0 and the memory card slot 1 of a basic control unit (BCU0). Memory
cards must be installed into both BCU0 and BCU1 in case that a basic control unit is redundant.
Caution While the access indicator of BCU (ACC lamp) is lit, the memory card is being accessed. DO NOT
pull out a memory card or turn off the power switch while the memory card is being accessed. If
so, you could permanently damage the memory card.
NOTE When inserting a memory card, the surface labeled with the part number "HN-F9244-66X" should
be faced up.
QSGGR4K00-10 5794047-1X
1
.
GR4000 Quick Start Guide, Revision 1 - Preliminary
3.
Procedure
Connect a setup terminal to
GR4000-160E1.
5.
Procedure
Power on
GR4000-
160E1.
11