Hitachi GR4000 Series Quick Start Manual page 30

GR4000 Quick Start Guide, Revision 1 - Preliminary
Setup of GR4000-160E2
●Setup procedures
6.
Procedure
Check LED.
4.
Procedure
Attach an interface
cable.
2.
Procedure
Install a memory card.
Figure 2-7 Procedures for GR4000-160E2 setup
1.
Procedure
Attach a power cable
Attach power cables to all the power supply units in GR4000-160E2.
GR4000-160E2 requires DC cables. See the GR4000 Hardware Installation Guide if you want to know how to
attach DC cables.
2.
Procedure
Install a memory card.
Insert a memory card into both the memory card slot 0 and the memory card slot 1 of a basic control unit (BCU0). Memory
cards must be installed into both BCU0 and BCU1 in case that a basic control unit is redundant.
Caution While the access indicator of BCU (ACC lamp) is lit, the memory card is being accessed. DO NOT
pull out a memory card or turn off the power switch while the memory card is being accessed. If
so, you could permanently damage the memory card.
NOTE When inserting a memory card, the surface labeled with the part number "HN-F9244-66X" should
be faced up.
NOTE Use a standard type of memory card provided by HITACHI. The operation cannot be guaranteed if
a memory card other than that is used.
When installing a memory card using an option license for GR4000, make sure that the
manufacturing number of a device put on the label of a memory card matches the serial number
of an option license. (You can check these numbers using a packing list provided with GR4000.)
14
3.
Procedure
Connect a setup terminal to GR4000-160E2.
1.
Procedure
Attach a power cable.
5.
Procedure
Power on GR4000-160E2.
QSGGR4K00-10 5794047-1X