Toro Multi Pro 1750 Operator's Manual page 17

Figure 32
1. Right-boom mount
(supporting the center
boom section)
2. Ball-valve bracket
3. Drill and 6.5 mm (1/4 inch)
drill bit
4. Line
2. Center the holes of the ball valve bracket to the line
that you marked in step 1. and center the bracket to the
across right boom mount
Note: Use the ball valve bracket for a drilling template.
3. Mark the holes in the bracket onto the right boom
mount and center punch the marks.
4. Using a drill and a 6.5 mm (1/4 inch) drill bit, drill 2
holes into the frame
5. Assemble the ball valve to the ball valve bracket
33) with 2 bolts (5/16 x 5/8 inch).
5. 15.2 cm (6 inch)
6. Mounting plate (right frame
channel)
7. Rear of the machine
(Figure 32).
(Figure 32).
1
1. Bolt (5/16 x 5/8 inch)
2. Ball valve bracket
6. Install the ball valve and valve mount bracket to the
machine with 2 hex-head bolts (6 x 16 mm) and 2
flange nuts (6 mm)
1. Hex-head bolt (6 x 16 mm) 2. Locknut (6 mm)
(Figure
17
3
2
3
Figure 33
3. Straight-barbed fitting
(1-1/4 inch NPT x 3/4 inch)
4. Ball valve
(Figure 34).
1
2
Figure 34
4
g024826
g024828