Toro Multi Pro 1750 Operator's Manual page 25

Figure 49
1. Hose conduit
2. Straight-barbed fitting
(tank rinse pump)
3. Slip the hose conduit over the hose leaving about 30
cm (1 ft) of the free end of the hose exposed
49 and Figure 50).
Figure 50
1. Hose conduit
2. Hose 1.9 x 114 cm (3/4 x
45 inch)
4. Assemble the free end of the hose onto the 90° barbed
fitting at the bottom of the rinse tank
5. Secure the hose to the fitting with a hose clamp and
finish wrapping the end of the hose with the hose
conduit (Figure 50).
3. Hose clamp
4. Hose 1.9 x 114 cm (3/4 x
45 inch)
(Figure
3. Hose clamp
4. 90° barbed fitting
(Figure 50).
15
Installing Decals
Parts needed for this procedure:
1 Decal (120-0673)
1 Decal (120–0687)
Procedure
1. Thoroughly clean the surface of the 4-way valve bracket
and ball valve bracket
1. Decal 120–0673
1. Ball valve bracket
2. Peel the backing from the decal and install the decals to
the machine as shown in
25
(Figure 51 and Figure 52).
Figure 51
2. 4-way valve bracket
Figure 52
2. Decal 120-0687
Figure 51 and Figure 52).