Scan; Setting Of Scanner Functions (Scanner) - Canon imageRUNNER 1750 Series Service Manual

#SCAN

■ Setting of Scanner Functions (SCANNER)

Initial Appropriate
Item1 No.
setting guideline
#SCAN SW SW00 - 04
SW05: Differs
according
to the
location.
SW06
#SCAN 001: - 032:
NUMERIC
033: 50
034: 50
035: - 046:
047: 50
048: 50
049: - 134:
135: 30
136: - 137:
138: 15
139: - 144:
145: 30
146: 30
147: 10
148: 25
149: - 164:
165: 4
166: - 167:
168: 0
169: - 192:
8
Service Mode > Details of Service Mode > #SCAN > Setting of Scanner Functions (SCANNER)
Description
Not used
Changes "AB configuration/Inch configuration"
of the original size detection
Not used
Not used
Vertical scan magnification correction (scanning
on BOOK)
Horizontal scan magnification correction
(scanning on BOOK)
Not used
Vertical scan magnification correction (scanning
on ADF)
Horizontal scan magnification correction
(scanning on ADF)
Not used
Leading edge trimming length when performing
fax operation using the Copyboard (0.1 mm)
Not used
Leading edge frame length when performing
copy operation using the Copyboard (0.1 mm)
Not used
Leading edge trimming length when performing
fax operation using the ADF (0.1 mm)
Trailing edge trimming length when performing
fax operation using the ADF (0.1 mm)
Left-right frame length when performing fax
operation using the ADF (0.1 mm)
Leading edge frame length when performing
copy operation using the ADF (0.1 mm)
Not used
Leading edge frame length when performing
SEND SCAN using the Copyboard (0.1 mm)
Not used
Leading edge frame length when performing
SEND SCAN using the ADF (0.1 mm)
Not used
8 Service Mode > Details of Service Mode > #SCAN > Setting of Scanner Functions (SCANNER)
Initial Appropriate
Item1 No.
setting guideline
193: 0 0: LEGAL
1: FOOLSCAP
2: M_OFICIO
3: A_FOOLSCAP
4: FOLIO
5: G_LEGAL
7: B_OFICIO
8: OFICIO
9: E_OFICIO
10: F4A
195: 0 0: LTR_R
1: FOOLSCAP
2: OFFICIO
4: G_LTR_R
6: K_LGL_R
7: EXE_R
196: - 290:
8-22
Description
ADF special paper, standardized size:
LGL misidentification-ready
To enable the change in this service mode, the
following settings need to be changed:
#SCAN > #SCAN SW > SW05,
#SYSTEM > #SYSTEM SW > SW57
ADF special paper, standardized size:
LTR_R misidentification-ready
To enable the change in this service mode, the
following settings need to be changed:
#SCAN > #SCAN SW > SW05,
#SYSTEM > #SYSTEM SW > SW57
Not used
T-8-31
8-22