Table of Contents
Advertisement
Connections (Continued)
HD Monitor RGB Connections
Antenna
OR
1 1
Connect the "Antenna/Cable" to the "ANT IN" jack on the HDTV Receiver using a coaxial RF cable.
1 1
ote
There might be some areas where the signal strength could be too high. If so, you may need to connect the
antenna to an attenuator. Screw the attenuator onto the "ANT IN" jack. (Refer to page 10.)
Connect the "ANT LOOP OUT" jack from the HDTV Receiver to the "Antenna In" jack on your TV using a coaxi-
2 2
al RF cable.
Connect the "RGB OUT" jack from the HDTV Receiver to the "RGB IN" jack on your TV using VGA-type connec-
3 3
tor. (The Output Selection must be set to RGB, refer to Display Format Setup on page 17.)
Connect the L/R "AUDIO OUT" jacks from the HDTV Receiver to the L/R "AUDIO IN" jacks on your TV using
4 4
RCA-type cables.
ote
1080i, 720p, and 480p modes are available for RGB outputs.
Cable TV
Wall Jack Panel
HD Ready TV Connection Panel
ANTENNA
S-VIDEO
RGB INPUT
INPUT
INPUT
HDTV Receiver Connection Panel
VIDEO
AUDIO INPUT
INPUT
R
L
To AUDIO OUT
13
Advertisement
Table of Contents
