Table of Contents
Advertisement
Connections (Continued)
HD Monitor DVI-HDTV Connections
Antenna
1 1
Connect the "Antenna/Cable" to the "ANT IN" jack on the HDTV Receiver using a coaxial RF cable.
1 1
ote
There might be some areas where the signal strength could be too high. If so, you may need to connect the
antenna to an attenuator. Screw the attenuator onto the "ANT IN" jack. (Refer to page 10.)
Connect the "ANT LOOP OUT" jack from the HDTV Receiver to the "Antenna In" jack on your TV using a coaxi-
2 2
al RF cable.
Connect the "DVI OUT" jack from the HDTV Receiver to the "DVI IN" jack on your TV using DVI-D type connec-
3 3
tor. (The Output Selection must be set to DVI, refer to Display Format Setup on page 17.)
Connect the L/R "AUDIO OUT" jacks from the HDTV Receiver to the L/R "AUDIO IN" jacks on your TV using
4 4
RCA-type cables.
ote
• 1080i, 720p, and 480p modes are available for DVI outputs.
• A DVI-HDTV input is one that is compliant with EIA-861 and HDCP specifications. Check your TV or monitor's
user manual to find out if the TV or monitor's DVI input is compliant with these specifications.
• Some HD Monitors designed for PC applications using DVI-D may not work with this connection.
14
Cable TV
Wall Jack Panel
OR
HD Ready TV Connection Panel
ANTENNA
S-VIDEO
VIDEO
INPUT
INPUT
INPUT
To AUDIO OUT
HDTV Receiver Connection Panel
AUDIO INPUT
DVI-HDTV INPUT
L
R
Advertisement
Table of Contents
