Copying An Application - ABB CP415 Installation And Operation Manual

Operation
6.8

Copying an Application

To copy an application from one CP415 to another CP415, select Copy from
the system menu. Set the dip switch SW7 = ON and connect the two operator
terminals with a download cable. After the self-test, the system menu will be dis-
played on the screen.
Select Copy in the system menu from the operator terminal with the application
to be copied. The operator terminal will prompt for a password: enter the pass-
word set in CP400Soft from Application/Workstation Setup. Once the correct
password is entered, the CP415 starts to copy the application to the other
CP415.
For information about setting a password, please see section 6.9 Passwords.
The following appears on the screens during the copying:
Note:
When copying for the first time, make sure to first run the application once, or
else the copy function will not work.
ABB, 1SBC159107M0201 21