Table of Contents
Advertisement
I/O connector
This section shows the wiring for an I/O connector.
Wiring equipment
The following shows the equipment for wiring.
■connector
The I/O connector specifications are as follows.
1
2
3
4
5
6
Pin numbers Signal code
*1
1
NC
2
3
SHUTDOWN IN +
4
SHUTDOWN IN -
5
SHUTDOWN OUT +
6
SHUTDOWN OUT -
*1 Do not connect anything.
■Power wiring
When connecting to the I/O connector, use power wiring with the following specifications.
Power wiring
Stranded wire
■Solderless terminal
Use the following solderless terminals for wiring.
Solderless terminal
Insulated bar solderless terminal
■tool
Use screwdrivers that meet the following conditions.
• Flathead screwdriver (shaft diameter: 3 mm or less, blade width: 2.6 mm or less)
Signal name
Unused terminal
Shutdown request input
Shutdown request input common
Shutdown completed output
Shutdown completed output common
Diameter
0.25 to 0.75
Model name
• AI 0.25 to 10 YE (used wire: 0.25 )
• AI 0.34 to 10 TQ (used wire: 0.3 , 0.34 )
• AI 0.5 to 10 WH (used wire: 0.5 )
• AI 0.75 to 10 GY (used wire: 0.75 )
Application
Shutdown request signal input terminal
Shutdown request signal common terminal
Shutdown completed signal output terminal
Shutdown completed signal common terminal
Manufacturer
Phoenix Contact
(www.phoenixcontact.com)
Type
NC
Input
Output
APPX
161
Appendix 10 Wiring
A
Advertisement
Table of Contents
