Table of Contents
Advertisement
Important notes and advice:
•
Warning:
For obvious safety reasons, all connections must be made with the power
disconnected (protection circuit breaker in the OFF position).
• Before installation, you are advised to check that your WiFi network signal is accessible and of
sufficient quality in the place where you wish to install your camera.
• If you are testing the camera before installation, we recommend that you switch off the motion
and figure detection function to prevent the camera motor from moving when you install it in its
final location (the camera has a battery backup).
• The installation and use of the camera must comply with current laws.
• The camera power supply is 100 - 240 V 50 Hz.
5.1. Installing the base
1
1
1
1
4
4
4
4
1. Cut off the power supply (safety switch to the OFF position).
2. Using the tool provided, unscrew the screw under the base at the back of the camera.
Important:
it is normal for the screw to retract when you unscrew it.
3. Remove the base from the camera.
4. On the wall, mark the location of the 4 holes for wall mounting and the position of the power
cable. The optimum height for installing the camera is between 2.20 and 2.40 metres.
5. Drill the holes. The screws and plugs supplied are suitable for solid material; you may need to
adapt the fastening to your particular substrate.
6. Screw the wall plate securely to the wall, passing the electrical cable through the centre. If the
wall surface is uneven, insert the sheet of foam supplied between the base and the wall.
4
2
2
2
2
5
5
5
5
WelcomeEye View / V1
3
3
3
3
6
6
6
6
4
4
4
Advertisement
Table of Contents
